Jason
RRCRat Rig Community [Unofficial]
•Created by Jason on 1/22/2025 in #ratos-support
Rat rig VAOC 3DO Webcam not working in visual calibration
I was able to at least manually figure out the xyz offsets between t0 and t1 by plugging in the webcam into my laptop and maneuvering the two nozzles in focus and writing down their positions when focused, calculating the differences and then plugging them into the configurations. However that raises more questions about where those values go. As far as I can tell, if the delta (change) is calculated as {T1-T0}, then you adjust the x offset by plugging into the printer.cfg deltaX
[dual_carriage]
position_max: 559.2 #560 minus {delta x}
position_endstop: 559.2 #same
then for the y and z offsets, you goto the ratos-variables.cfg
idex_yoffset = 0.4 # 0 minus {delta y}
idex_zoffset = 0.1 # 0 minus {delta z}
Checking back on the camera (visible only on the laptop connected the VAOC camera) this all seems to work. But there are a bunch of other parameters which seem to be relavent to all these offsets. Can anyone tell me if this workaround is flawed?
15 replies
RRCRat Rig Community [Unofficial]
•Created by Jason on 1/22/2025 in #ratos-support
Rat rig VAOC 3DO Webcam not working in visual calibration
Yea the camera shows on the mainsail webcam, but only when using the default setting for the stream. It becomes a bit comical when you can see your camera show up at the bottom of the dashboard but not in "visual calibration". I can turn on the backlight for the LED and everything.
15 replies
RRCRat Rig Community [Unofficial]
•Created by Leymz on 1/16/2025 in #ratos-support
RPICamv2 doesn't start as an VAOC cam.
Im having the same problem with not being able to see my Ratrig VAOC 3DO camera in the visual calibration page. "webcam not found". I followed all the steps everywhere on discord and on the ratrig pages and oddly enough, though I can see the camera video fine through the settings page, that i can see the crowsnest log show the device, when I ssh into the raspberry pi and try to list the cameras via libcamera-hello i get "error no devices found". But when i go through mainsail machine->devices and list the devices, its shown there!!? How to resolve this issue??
26 replies
RRCRat Rig Community [Unofficial]
•Created by heathadamburke on 12/31/2024 in #fix-my-printer
VAOC not working
I'm having the same issue. I tried to use the ustreamer option hoping that I could at least get the printer somewhat operational, but no luck.
18 replies