P. Skirde
RRCRat Rig Community [Unofficial]
•Created by 3d_flx on 3/23/2025 in #german-support
First Layer / Beacon Compensation / Z Offset
Ich habe genau das gleiche Problem, aber noch keine Lösung. Kann das Thema noch mal aufgegriffen werden?
43 replies
RRCRat Rig Community [Unofficial]
•Created by P. Skirde on 2/14/2025 in #fix-my-print
(IDEX VC4 500) Random layer shifts despite a lot of troubleshooting
I had the feeling the shift could be related to my T0 X drive (if you call it X in hybrid?), the shift direction would fit
10 replies
RRCRat Rig Community [Unofficial]
•Created by P. Skirde on 2/14/2025 in #fix-my-print
(IDEX VC4 500) Random layer shifts despite a lot of troubleshooting
Will try this 👍
10 replies
RRCRat Rig Community [Unofficial]
•Created by P. Skirde on 2/14/2025 in #fix-my-print
(IDEX VC4 500) Random layer shifts despite a lot of troubleshooting
PrusaSlicer 2.9.0
10 replies
RRCRat Rig Community [Unofficial]
•Created by P. Skirde on 2/14/2025 in #fix-my-print
(IDEX VC4 500) Random layer shifts despite a lot of troubleshooting
Yes
10 replies
RRCRat Rig Community [Unofficial]
•Created by evilC on 10/24/2024 in #fix-my-printer
Layer shift - stepper skipping suspected
Did you find out anything more about this issue? I might have the same problem
11 replies