Flo@GRNbms Comments - Answer Overflow

Hi 🙋‍♂️ this are the first layer results after recommended changes. Heat soak the printer for 1hour and the loosen/tighten the x/y rail, cold pull, beacon calibration

84 replies

RRCRat Rig Community [Unofficial]

•Created by Flo@GRNbms on 12/15/2024 in #fix-my-print

First layer problem

Okay, I'll try that later. Are you following this discussion? (https://discord.com/channels/582187371529764864/1293322335545196655) Most people there solve it by changing the heightmap strategy. As I understand it, the basic problem is tension in the material when it heats up. Is that right?

84 replies

RRCRat Rig Community [Unofficial]

•Created by Flo@GRNbms on 12/15/2024 in #fix-my-print

First layer problem

84 replies

RRCRat Rig Community [Unofficial]

•Created by Flo@GRNbms on 12/15/2024 in #fix-my-print

First layer problem

I'm a little confused, and it seems as if in the end it always comes down to loading the correct height map and heating up the bed for a long time. I run the V-Core with the default RatOs settings without any modifications. That should actually work, right?! As I understand it, the problem should be solved by loosening the gantry/rail screws. So that the different shape of the material doesn't cause tension. Have I understood that correctly? Or is there a working solution that deviates from the default RatOs setting?

84 replies

RRCRat Rig Community [Unofficial]

•Created by Flo@GRNbms on 12/15/2024 in #fix-my-print

First layer problem

@tg73 Yes, this is exacly the problem i had here. It seems a lot of other users have the same issue ...

84 replies

RRCRat Rig Community [Unofficial]

•Created by dead_again on 12/9/2024 in #fix-my-print

first layer keeps getting worse while it’s printing

as longer i search for this problem on discord or google. I see a lot of user has the same problem with this. There is no solution or advice for it ?

33 replies

RRCRat Rig Community [Unofficial]

•Created by dead_again on 12/9/2024 in #fix-my-print

first layer keeps getting worse while it’s printing

same problem on my side 😣

33 replies

RRCRat Rig Community [Unofficial]

•Created by Flo@GRNbms on 12/15/2024 in #fix-my-print

First layer problem

how it should look in printer.cfg ?

84 replies

RRCRat Rig Community [Unofficial]

•Created by Flo@GRNbms on 12/15/2024 in #fix-my-print

First layer problem

yes i found a advice from @Helge Keck to solve this problem. Add code to printer.cfg to heatsoak bed and nozzle. But it don’t fix the problem

84 replies

RRCRat Rig Community [Unofficial]

•Created by Flo@GRNbms on 12/15/2024 in #fix-my-print

First layer problem

@MurmelMannen here u can see the flow and z offset are okay. But then it goes closer and closer …. bed mesh should handle this normally 🤒 but it doesn’t.

84 replies

RRCRat Rig Community [Unofficial]

•Created by Flo@GRNbms on 12/15/2024 in #fix-my-print

First layer problem