Riosrichie
RRCRat Rig Community [Unofficial]
•Created by Riosrichie on 9/30/2024 in #ratos-support
MERCURY ONE.1 W/Hydra & RatOS Unable to home Z
someone please help me figure this out, I've been at this for days now and I'm about ready to toss it . I'm having trouble with the BLtouch section, i am currently using the BIQU Microprobe and the Manta M8P 2.0 W/ CB1. i get the error "BLTouch failed to verify sensor state" i thought there was a working Microprobe.cfg that could be copied and pasted to the printer.cfg but I'm not having any luck going that route either. I thought i understood the assignment..... clearly i didn't
any and all help would be greatly appreciated, Thanks
any and all help would be greatly appreciated, Thanks
9 replies