MERCURY ONE.1 W/Hydra & RatOS Unable to home Z
someone please help me figure this out, I've been at this for days now and I'm about ready to toss it . I'm having trouble with the BLtouch section, i am currently using the BIQU Microprobe and the Manta M8P 2.0 W/ CB1. i get the error "BLTouch failed to verify sensor state" i thought there was a working Microprobe.cfg that could be copied and pasted to the printer.cfg but I'm not having any luck going that route either. I thought i understood the assignment..... clearly i didn't
any and all help would be greatly appreciated, Thanks
any and all help would be greatly appreciated, Thanks
6 Replies
you need to also include your ratos.cfg
sorry about that, i didn't notice i missed a file
Biqu microprobe is quite different than bltouch… CAN’T be configured like a bltouch.
I will share a working config soon.
Microprobe is not supported by RatOS 2.1 (yet)
exactly what I said before.
You have a bltouch set up on RatOS but the MicroProbe does not work like it.
Check this
https://github.com/Rat-OS/RatOS-configuration/blob/v2.1.x/z-probe/microprobe.cfg
And this
https://github.com/bigtreetech/MicroProbe/blob/master/MicroProbe%20V2%20User%20Manual_20240330.pdf
GitHub
RatOS-configuration/z-probe/microprobe.cfg at v2.1.x · Rat-OS/RatOS...
The RatOS modular klipper configuration. Contribute to Rat-OS/RatOS-configuration development by creating an account on GitHub.
GitHub
MicroProbe/MicroProbe V2 User Manual_20240330.pdf at master · bigtr...
Contribute to bigtreetech/MicroProbe development by creating an account on GitHub.
ok i see, So i think it would be easier to just get a new/supported sensor. ill order the beacon sensor, from what i see there seems to be a ton of support around that sensor so i cant go wrong with it.
They all end working.
But beacon is THE sensor nowadays.