Ian_2024
RRCRat Rig Community [Unofficial]
•Created by Ian_2024 on 2/24/2024 in #fix-my-printer
Problem with Beacon RevD after upgrading to ratOS 2.0.2
Well it turned out that I was an dumb idiot, - I ignored the instruction in printer.cfg that simply said " just connect it and run BEACON_CALIBRATE" - I was afraid to do the Beacon_Calibrate before checking it's operation to make sure I did not crash the head into the bed, run the macro and like magic all worked. - Sorry to waste anyones time!
11 replies
RRCRat Rig Community [Unofficial]
•Created by Ian_2024 on 2/24/2024 in #fix-my-printer
Problem with Beacon RevD after upgrading to ratOS 2.0.2
Sorry for the late response. I had tried that befor and retried after your post, but no change, I will wait until my RevH arrives, In the meantime have switched back to superpinda. Thanks for the response!
11 replies
RRCRat Rig Community [Unofficial]
•Created by Ian_2024 on 2/24/2024 in #fix-my-printer
Problem with Beacon RevD after upgrading to ratOS 2.0.2
I am certain I tried this, But will retry tomorrow and let you know. - Thanks for the replies guys.
11 replies
RRCRat Rig Community [Unofficial]
•Created by Ian_2024 on 2/24/2024 in #fix-my-printer
Problem with Beacon RevD after upgrading to ratOS 2.0.2
No Change - Triggered
11 replies