Coeus Comments - Answer Overflow

Argh. just mashed my print. Forgot to take it off the bed before starting another print. Hope I didn't squash my settings or mangle parts... Besides - I thought Beacon Contact was supposed to eliminate that aspect ... I haven't been able to use the default homing method variables at all that are described in the beacon documentation.

37 replies

RRCRat Rig Community [Unofficial]

•Created by Coeus on 1/19/2025 in #ratos-support

Print Fail during beacon calibration after update - bug?

Restarting print file where error was encountered.

37 replies

RRCRat Rig Community [Unofficial]

•Created by Coeus on 1/19/2025 in #ratos-support

Print Fail during beacon calibration after update - bug?

Here is output: ✓ Fixing potential RatOS issues... ✓ Repaired RatOS configurator ✓ Restarted RatOS configurator ✓ Repaired RatOS configuration ✓ Restarted Klipper ✓ Restarted Moonraker Done! Running: $ sudo systemctl restart moonraker

37 replies

RRCRat Rig Community [Unofficial]

•Created by Coeus on 1/19/2025 in #ratos-support

Print Fail during beacon calibration after update - bug?

Print finished - running ratos doctor.

37 replies

RRCRat Rig Community [Unofficial]

•Created by Coeus on 1/19/2025 in #ratos-support

Print Fail during beacon calibration after update - bug?

Understood - just checked both slicers and referenced os.ratrig.com slicer info - My settings match the docs.

37 replies

RRCRat Rig Community [Unofficial]

•Created by Coeus on 1/19/2025 in #ratos-support

Print Fail during beacon calibration after update - bug?

What should I expect from ratos doctor?

37 replies

RRCRat Rig Community [Unofficial]

•Created by Coeus on 1/19/2025 in #ratos-support

Print Fail during beacon calibration after update - bug?

I will double check - but certain I copied them from the docs.

37 replies

RRCRat Rig Community [Unofficial]

•Created by Coeus on 1/19/2025 in #ratos-support

Print Fail during beacon calibration after update - bug?

My print will be done in about 10 mins. I'll grab it afterwards - don't want to spook the Fates.

37 replies

RRCRat Rig Community [Unofficial]

•Created by Coeus on 1/19/2025 in #ratos-support

Print Fail during beacon calibration after update - bug?

hmmm - so here's another data point. I use multiple slicers depending on features that I need. I swapped over to using Prusa with the same model and I'm able to print without an error. I need to see what the diffs are. But I had copied over the machine g-code start, finish, etc into all of the slicers - SS, Orca, Prusa. (all latest versions) @TheTik yes - thanks.

37 replies

RRCRat Rig Community [Unofficial]

•Created by Coeus on 1/19/2025 in #ratos-support

Print Fail during beacon calibration after update - bug?

Full config attached here with ratos-debug zip archive file

37 replies

RRCRat Rig Community [Unofficial]

•Created by Coeus on 1/19/2025 in #ratos-support

Print Fail during beacon calibration after update - bug?

will do.

37 replies

RRCRat Rig Community [Unofficial]