billanboy
RRCRat Rig Community [Unofficial]
•Created by billanboy on 1/24/2025 in #fix-my-printer
unable to read tmc uart 'stepper_z' register ifcnt
turns out the labeling is the same on the 1.0 and 1.1 board and i had the 1.1 board so after a reflash it works no just have the get the beacon to calibrate succesful 🙂
14 replies
RRCRat Rig Community [Unofficial]
•Created by billanboy on 1/24/2025 in #fix-my-printer
unable to read tmc uart 'stepper_z' register ifcnt
i re-flashed, changed the stepper between motor 6 and 7 and changed the motor and its still giving the same fault
14 replies
RRCRat Rig Community [Unofficial]
•Created by billanboy on 1/24/2025 in #fix-my-printer
unable to read tmc uart 'stepper_z' register ifcnt
didnt work...
14 replies
RRCRat Rig Community [Unofficial]
•Created by billanboy on 1/24/2025 in #fix-my-printer
unable to read tmc uart 'stepper_z' register ifcnt
okay i try in a few hours. thanks 🙂
14 replies
RRCRat Rig Community [Unofficial]
•Created by billanboy on 1/24/2025 in #fix-my-printer
unable to read tmc uart 'stepper_z' register ifcnt
yes! the only thing i changed was connecting the hotend thermistor to the toolboard instead of the controllerboard
14 replies
RRCRat Rig Community [Unofficial]
•Created by billanboy on 1/24/2025 in #fix-my-printer
unable to read tmc uart 'stepper_z' register ifcnt
here is the config i hade when klipper was on it, from what i can see the z stepper pinout is different but its connected as the documentation says.
14 replies
RRCRat Rig Community [Unofficial]
•Created by billanboy on 1/24/2025 in #fix-my-printer
unable to read tmc uart 'stepper_z' register ifcnt
14 replies
RRCRat Rig Community [Unofficial]
•Created by billanboy on 1/24/2025 in #fix-my-printer
unable to read tmc uart 'stepper_z' register ifcnt
14 replies
RRCRat Rig Community [Unofficial]
•Created by billanboy on 1/24/2025 in #fix-my-printer
unable to read tmc uart 'stepper_z' register ifcnt
where do i find debug.zip?
14 replies