unable to read tmc uart 'stepper_z' register ifcnt
i had klipper on the ratrig 300 and just flashed RatOS, i followed the guide and cant figure this out. it was working with klipper!
i got the M8P with tmc2209. any idea?
11 Replies
Drop your printer.cfg and debug.zip please.
where do i find debug.zip?
here is the config i hade when klipper was on it, from what i can see the z stepper pinout is different but its connected as the documentation says.
So the exact same board and wiring worked in a vanilla klipper install, then you tried to flash ratos and are having issues?
yes! the only thing i changed was connecting the hotend thermistor to the toolboard instead of the controllerboard
Try re-seating each of the stepper drivers. Sounds like one isn't communicating properly.
okay i try in a few hours. thanks 🙂
Good luck!
didnt work...
i re-flashed, changed the stepper between motor 6 and 7 and changed the motor and its still giving the same fault
turns out the labeling is the same on the 1.0 and 1.1 board and i had the 1.1 board so after a reflash it works no just have the get the beacon to calibrate succesful 🙂