Rok4t
RRCRat Rig Community [Unofficial]
•Created by San_Holo on 2/13/2025 in #fix-my-printer
First layer is going to drive me crazy
dont know if the calibration was needed but did it anyway
10 replies
RRCRat Rig Community [Unofficial]
•Created by San_Holo on 2/13/2025 in #fix-my-printer
First layer is going to drive me crazy
had also Z-Offset problems. what worked for me was to reset the nozzle_expansion_coefficient_multiplier in ratos-variables to 1 and nozzle_expansion_coefficient_t0 to 0.06 and after that rerun the BEACON RATOS CALIBRATE after heatsoak the printer
10 replies
RRCRat Rig Community [Unofficial]
•Created by pd on 3/7/2025 in #fix-my-print
Sharp corners on small part being rounded
pressure advanced
17 replies
RRCRat Rig Community [Unofficial]
•Created by pd on 3/7/2025 in #fix-my-print
Sharp corners on small part being rounded
did you dial in your PA?
17 replies