BaldMac
RRCRat Rig Community [Unofficial]
•Created by azoroes on 5/24/2024 in #fix-my-print
First Layer problems
Hi . I did post a reply but dint mark it as such. see below
4 replies
RRCRat Rig Community [Unofficial]
•Created by azoroes on 5/24/2024 in #fix-my-print
First Layer problems
Hi. I also have a V core 3.1 500 and though my first layer print isn't perfect, it is always compete and useable. It does show some areas which are nozzle too close and some too far away but is acceptable. I use a 0.4 nozzle and print the first layer at 0.275. . I use Sunlu PLA+ which I print at 300mm/S for most everything. I do note that your bed mesh does have a lot of detail and I'm wondering how repeatable and realistic that actually is. I don't do a mesh with as fine a matrix as you but it is very reproducible. Have you run this a number of times back to back to see just how reproducible it is. My Z offset is quite temperature sensitive, not sure if it's the super Pinda or the actual bed but it does vary quite a bit. Note that I don't pretend to be an 3D printer expert but generally I get very good prints from the Ratrig 3.1
4 replies