Blanka
RRCRat Rig Community [Unofficial]
•Created by Blanka on 9/13/2024 in #fix-my-printer
V Chonk bed tramming
Hi everyone, I have a pretty big issue on my V-Chonk. I just finished building it, wiring everything up (it works) and I can't figure how to make the bed even with the gantry (for reference what you do via the z tilt on the v core).
I tried lowering it all on the base, but when it goes up it slightly loses the squareness, I tried leveling it manually with the toolhead rotating the M8 screws but the tolerance is still too high.. I don't know what to do. Like this is unusable. I run the stock setup (SKRat with no toolboard), 2 TMC5160 for XY and 2209 for the rest.
If anyone can help me I'd be extremely happy 😦
2 replies
RRCRat Rig Community [Unofficial]
•Created by Blanka on 4/29/2024 in #ratos-support
Boards disconnects with probe
Hi again guys, finally i'm at my last problem after rebuilding my v minion!
The cheap inductive probe that came at the beginning with the kit now gives me this problem: as soon as i attach it, the mcu loses communication with the pi. As i detach it, printer immediately works again. What could be? Fortunately today or tomorrow i'll take delivery of the super pinda the good one
2 replies
RRCRat Rig Community [Unofficial]
•Created by Blanka on 4/29/2024 in #ratos-support
Grinding noise X axis
Hi guys, today in my V minion, after a full rebuild, the X axis makes a grinding noise while moving, and doesn't home correctly. What could it be? I also swapped board from octopus to octopus pro, but i also updated the cfg and in fact the Y axis works correctly. Mechanically it's okay, maybe a little gone the carriage, but not that much to make that noise, by hand it doesnt do that.
3 replies