Renfeld
RRCRat Rig Community [Unofficial]
•Created by Renfeld on 6/16/2024 in #fix-my-printer
Input shaper error in config
as soon as I remove the # from the pid tuning, it won't connect
8 replies
RRCRat Rig Community [Unofficial]
•Created by Renfeld on 6/16/2024 in #fix-my-printer
Input shaper error in config
so I added spaces before 200,200,20 #400mm printer
that made it work.
Now I'm getting:
Printer is not ready
The klippy host software is attempting to connect. Please
retry in a few moments.
8 replies
RRCRat Rig Community [Unofficial]
•Created by Renfeld on 6/16/2024 in #fix-my-printer
Input shaper error in config
[resonance_tester]
accel_chip: ebb42
ADXL345 resonance testing configuration
probe_points:
100,100,20 # 200mm printer
150,150,20 # 300mm printer
200,200,20 # 400mm printer
250,250,20 # 500mm printer
8 replies
RRCRat Rig Community [Unofficial]
•Created by Renfeld on 6/16/2024 in #fix-my-printer
Input shaper error in config
Still getting this error even with your assistance. Thank you though
8 replies
RRCRat Rig Community [Unofficial]
•Created by Renfeld on 6/16/2024 in #fix-my-printer
Input shaper error in config
Source contains parsing errors: '/home/pi/printer_data/config/printer.cfg'
[line 96]: '200,200,20 \n'
8 replies
RRCRat Rig Community [Unofficial]
•Created by Renfeld on 6/27/2023 in #fix-my-resonance
What should I do from here?
I hear belt slap when it's doing 55-62hz upper and 53-59hz on lower is this normal?
5 replies
RRCRat Rig Community [Unofficial]
•Created by Renfeld on 6/27/2023 in #fix-my-resonance
What should I do from here?
5 replies