RatOS 2.1.0-RC2 Reporting that it cant write to stepper_x's Globalregister.
Hello, so I just got done building a v-core 4, however my machine is non standard. I'm running an Octopus Pro 723 v1.1 board, 1 48v poser supply and 1 24v power supply using tmc 5160 pro v 1.1 drivers on the hybrid motion system (voltages altered to the suggested settings in RatOS) and tmc 2209's/24v on the z axis steppers (standard volatage).
Whenever I go to home klipper shuts down reporting that it cant write to "stepper_x globalregister". I did some research online and found that this usually means bad hardware. So I swapped the tmc 5160's around a few times - error was always stepper x. Thinking it was a bad board I swapped it for an older octopus pro 446 I had in another printer (known good board) - same issue. I'm starting to think that maybe its software related.
I'm currently going to try falling back to 2.1.0-rc1 to see if that makes a difference. Let me know if anyone else is having this issue and/or what files you need form me to assess things.
4 Replies
... or what files you need form me to assess thingshttps://discord.com/channels/582187371529764864/1233461645167169576 rule #2 the logs and config files
Did you set the 5160 driver jumpers to SPI mode? The 2209s are uart mode
@chicken so I followed the guide which had you pull the jumpers to put them into uart if they should be in SPI then that should be an easy fix and I'll give it a go
@chicken that was it thanks!
The guide was written for stock electronics which are all uart. Glad that worked.