Topics

Rat Rig Community [Unofficial]•2w ago

Help! How do I make my IP static?

Sorry if this has been asked before but my IP changes everytime I turn on my printer.

Solution:

Best to set that up in your DHCP provider (usually your router)

Jump to solution

3 Replies

Solution

blacksmithforlife•2w ago

Best to set that up in your DHCP provider (usually your router)

chicken•2w ago

agreed, its normally easier to just let the printer use DHCP and then setup a static DHCP reservation on your router. That way if anything updates on your network the printer will be updated next time it renews its address

DJDupid•2w ago

Thank you. I will try that out.

Rat Rig Community [Unofficial]Join

12KMembers

View on Discord

Want results from more Discord servers?

Add your server

More Posts

adding beacon mesh points?Running ratOS 202 with beacon revH Is there an easy way to add a bit to my printer cfg that will a Manta M8P v2 with cb1Hello to all, I’m working on this trouble almost 3 days . Unfortunately, I can’t get it set up . May Klipper reports: ERRORSection 'gcode_shell_command generate_shaper_graph_x' is not a valid configI tried the troubleshooting guide but the http://ratos.local/configure wont open *After a Pause & Resume MCU 'mcu' shutdown: Rescheduled timer in the pastDuring a print, I have pressed pause (on my klipperscreen), did some maintainance on the printed par M8P v2 mit CB1 und Ebb42 startet nichtHallo Freund, Ich brauch wieder eure Unterstützung. Ich hab hier ein Problem mit meinem Manta Board.Usb devices being reset during printDuring prints I'm losing usb connection to my tool board. Lost communication with MCU 'toolboard_t0 Motors not moving on newly-build GRBL/Arduino CNC mill.Does this channel have to be for Rat Rig machines? I figured I'd ask here since there has to be some Pressure advance tuning, infill weirdnessI am trying out the new pressure advance capabilities in RATOS 2.1 and am encountering an issue with Auto levelling problemHow to fix my auto levelling ?Z-offset problemI can’t fix the first layer and it always changes the Z-offset when i start it. How do i fix it?