Retries aborting: Probed points range is increasing.
Getting the message "Retries aborting: Probed points range is increasing." more often these days.. is this a mesh issue?
If it somehow manages to proceed, it's generally on the 7th z probe try.. Tolerance is 0.02.. any way to slightly increase this number?
Thanks.
3 Replies
probes increasing is a sign that either there is something wrong with your mechanical system (check your leadscrews and that the grub screws holding them haven't come loose) or that your probe is not firmly held in place
xenial-blackOP•13mo ago
Thanks blacksmithforlife. I was also able to adjust the gantry for much better results..
I've gotten that message during Z-Tilt since my magnet is not yet stuck to the aluminum bed but held on with tape. So sometimes the corners lift while performing Z-Tilt.
If you ruled out the mechanical system like blacksmithforlife said, check your magnet and PEI sheet adhesion to the bed, or if you have bubbles.
It could also be caused by thermal expansion when your bed is heating up, letting it heatsoak for a while might help.