top surface pattern
Getting a ripple effect on the top surface almost like the layers below are coming threw.
I have seen this on my other printers on the second layer only. Seems to keep stacking on my second printer. Both are running same extruder setup etc.
1.0mm nozzle and 0.4lh
3 Replies
It kinda looks like you have some gaps between the lines, is your extrusion multiplier too low?
Seems like turning up extrusion factor was needed for the 1.0mm nozzle. It's better but surface finish still not the best with the 1.0.mm
Perhaps the extruder is having difficulty keeping up with the flow rate you are asking for, does the problem go away at lower printing speeds?