MoX
RRCRat Rig Community [Unofficial]
•Created by karpkapital on 12/24/2024 in #ratos-support
Unknown g-code generator
@WrinklySackNick that works, thanks👍
24 replies
RRCRat Rig Community [Unofficial]
•Created by karpkapital on 12/24/2024 in #ratos-support
Unknown g-code generator
24 replies
RRCRat Rig Community [Unofficial]
•Created by karpkapital on 12/24/2024 in #ratos-support
Unknown g-code generator
in printer.cfg?
24 replies
RRCRat Rig Community [Unofficial]
•Created by karpkapital on 12/24/2024 in #ratos-support
Unknown g-code generator
I have the same problem. I would like to continue using Cura because only Cura supports alternating wall directions. Indispensable for me with ABS and ASA.
@Helge Keck what does the post processor do? what changes when it is switched off?
24 replies
RRCRat Rig Community [Unofficial]
•Created by Silverfox79 on 8/18/2024 in #ratos-support
Z-Endstop on Voron V0.1
fix works with my configuration, thanks
23 replies
RRCRat Rig Community [Unofficial]
•Created by Silverfox79 on 8/18/2024 in #ratos-support
Z-Endstop on Voron V0.1
it would be nice to have a selection in the configurator for the physical z-switch. you could also add the z-endstop position -0.1 for voron v01 and z-endstop position 120 for voron v02 as a selection
23 replies
RRCRat Rig Community [Unofficial]
•Created by Silverfox79 on 8/18/2024 in #ratos-support
Z-Endstop on Voron V0.1
thanks for this idea. it works well as a temporary solution
23 replies
RRCRat Rig Community [Unofficial]
•Created by Silverfox79 on 8/18/2024 in #ratos-support
Z-Endstop on Voron V0.1
23 replies
RRCRat Rig Community [Unofficial]
•Created by Silverfox79 on 8/18/2024 in #ratos-support
Z-Endstop on Voron V0.1
23 replies
RRCRat Rig Community [Unofficial]
•Created by Nebulator on 11/18/2023 in #ratos-support
Voron 2.4 Support
its not so easy like config a vc3.1. i have build a ldo Voron 2.4 these days and i have to change many things in RatOs. Wiring is different from ldo to RatOs.
11 replies