captinbeefycakes | Biqu B1
RRCRat Rig Community [Unofficial]
•Created by captinbeefycakes | Biqu B1 on 5/23/2024 in #fix-my-printer
accelerometer help
However, when I activate the resonance test it did indeed use my sensor for the auto tests.
10 replies
RRCRat Rig Community [Unofficial]
•Created by captinbeefycakes | Biqu B1 on 5/23/2024 in #fix-my-printer
accelerometer help
When you try to test the sensor it might work for you but mine still looked for a adxl due to some deeper os code.
10 replies
RRCRat Rig Community [Unofficial]
•Created by captinbeefycakes | Biqu B1 on 5/23/2024 in #fix-my-printer
accelerometer help
From what I’ve been able to deduce and see work, set your sensor up according to how btt explains in the guide for klipper but you need to put the include at the top most of the printer cfg and then adjust the probe points to center of your build volume
10 replies
RRCRat Rig Community [Unofficial]
•Created by captinbeefycakes | Biqu B1 on 5/23/2024 in #fix-my-printer
accelerometer help
Sorry for the dud question
10 replies
RRCRat Rig Community [Unofficial]
•Created by captinbeefycakes | Biqu B1 on 5/23/2024 in #fix-my-printer
accelerometer help
I figured it out. Just had to re direct a file.
10 replies
RRCRat Rig Community [Unofficial]
•Created by captinbeefycakes | Biqu B1 on 5/23/2024 in #fix-my-printer
accelerometer help
The printer sees the sensor mcu over usb but I just need to get the config to use it and not this stray adxl code someplace
10 replies