alexella.
RRCRat Rig Community [Unofficial]
•Created by phongshader on 12/21/2023 in #fix-my-printer
controller fan not shutting down
10 replies
RRCRat Rig Community [Unofficial]
•Created by phongshader on 12/21/2023 in #fix-my-printer
controller fan not shutting down
do I have the same set of paramaters also for a "always on fan port" as I have on the "controller_fan" ?
I have a 12V Noctua on a 24V RatRig and I would like to have the ability to control the fan by software.
the other option would be installing the fan using a small DC-DC convertor and that might work also
10 replies
RRCRat Rig Community [Unofficial]
•Created by phongshader on 12/21/2023 in #fix-my-printer
controller fan not shutting down
I want my controller fan to be always on since my electronics are enclosed in a tight box. It's a 12V Noctua running on 24V.
It works fine when it work sbut I want it always on. Current setting below, I run out of ideas:
[controller_fan controller_fan]
Pi fan
See the "controller_fan" section in example-extras.cfg for a complete
max_power: 0.25
shutdown_speed: 0
cycle_time: 0.00001
hardware_pwm: false
kick_start_time: 0.50
idle_timeout: 999999
The ammount of time (in seconds) after a stepper driver or heater
was active and the fan should be kept running. The default
is 30 seconds.
idle_speed: 0.18
heater: extruder,heater_bed
10 replies