elphilmino
RRCRat Rig Community [Unofficial]
•Created by elphilmino on 6/24/2024 in #ratos-support
Flashed the wrong board in the configurator, how to remove it?
During setup of RatOS V2.1, I ended up flashing my BTT MMB board instead of my EBB 42 toolboard (which took a lot of troubleshooting to figure out but we got it), but now if both board are plugged in I get the ADC out of range error because the MMB is being recognized and not the EBB 42. Anyone got any tips on how to re-flash the MMB or change the device id on it? I have enough issues with just trying to manually flash a board on my own let alone figure out how to fix this issue.
14 replies
RRCRat Rig Community [Unofficial]
•Created by elphilmino on 6/16/2024 in #ratos-support
Ratos 2.1 EBB42 V1.2 Pullup Resistor Issue
Looking for some direction here. I've seen this mentioned by others, but not seeing a solution for my issue. I'm trying to upgrade to RatOS V2.1 on my V-Core 3.1, but I'm getting ADC out of range errors on the toolboard, which is what the configurator calls out if the jumper isn't installed on the resistor. I installed the jumper yet still get the error. I reverted back to V2 with the jumper still installed and get the same error, but when I remove it my configuration works as expected. Am I missing a step here?
92 replies
RRCRat Rig Community [Unofficial]
•Created by elphilmino on 9/18/2023 in #ratos-support
Version: v0.11.0-275-g8ef0f7d7-dirty
I recently noticed that my Host version of RatOS says it's "dirty". I do not know what that means, but I thought it happened when I tried to install HappyHare onto my pi, so I reflahsed my SD card with a new version of RatOS and re-installed everything again but it stills says it's dirty.
Can anyone tell me if this is actually a problem or if it needs to be fixed?
Can anyone tell me if this is actually a problem or if it needs to be fixed?
3 replies