MikeS
RRCRat Rig Community [Unofficial]
•Created by MikeS on 12/4/2024 in #ratos-support
Adaptive Bed Mesh
I just purchased a Vcore 3.1 on the cheap that was not assembled verdy well. I have been going through the build including the wiring to finally arrive at printing. The Pinda probe seemed inconsistent so I upgraded to a Euclid probe.
Homing and z tilt go well but a problem with adaptive bed meshing. With the pinda probe adaptive bed mesh went ok but with the euclid probe once a print was started and z tilt was done, the toolhead would go to the center of the bed and do a probe that seemed to not recognize the probe then move to the purge blob spot but did not lower the bed and proceeded to knock the probe off. Not expected.
I have now returned to normal bed mesh ( no adaptive) and that probes with the Euclid probe fine except I originally had an error "horizontal_move_can't be less than probe's z_offset". My online search found a fix by adding
[bed_mesh]
horizontal_move_z: 7
to user overides in the printer.cfg
I would like to have adaptive bed mesh working but cant seem to find a fix. Any suggestions would be greatly appreciated.
5 replies