Lostnbrownsmead
RRCRat Rig Community [Unofficial]
•Created by Lostnbrownsmead on 2/8/2024 in #ratos-support
Today I upgraded to newest version of Beacon and Z tilt is not working.
I found the problem. It was a mechanical problem the Y motor pulley came loose. I was thinking what did I do LAST which was upgrade the Beacon Software. After watching it run I noticed that the Print head was moving erratically in one direction. Tightened and aligned both pulleys and now it works. On another note where can I find a guide on Git commands
9 replies
RRCRat Rig Community [Unofficial]
•Created by Lostnbrownsmead on 2/8/2024 in #ratos-support
Today I upgraded to newest version of Beacon and Z tilt is not working.
Thanks for the information I will look into the git commands
9 replies
RRCRat Rig Community [Unofficial]
•Created by Lostnbrownsmead on 2/8/2024 in #ratos-support
Today I upgraded to newest version of Beacon and Z tilt is not working.
do you know where I can find the information on how to revert to a previous version?
9 replies
RRCRat Rig Community [Unofficial]
•Created by Lostnbrownsmead on 2/8/2024 in #ratos-support
Today I upgraded to newest version of Beacon and Z tilt is not working.
I conducted a beacon-query and I received the following "Last reading: 2969746.35Hz, 21.00C, infmm" What does "infmm" indicate?
9 replies
RRCRat Rig Community [Unofficial]
•Created by Lostnbrownsmead on 2/8/2024 in #ratos-support
Today I upgraded to newest version of Beacon and Z tilt is not working.
I took a video of the printhead moving from the various probe positions and they appear to shift positions and eventually the printhead starts running into the rear endstop and the motor skips position resulting in the probe positions shifting towards the back of the printer.
9 replies