Kmarty
Kmarty
PostsComments
RRCRat Rig Community [Unofficial]
Created by Kmarty on 6/1/2023 in #ratos-support
FR: Ability to connect to "mixed WPA2-PSK/WPA3-SAE access points"
Hi, at this moment currently generated wpa_supplicant.conf by RatOS Configurator allows to connect to WPA/WPA2 networks only. To be able to connect to "mixed WPA2/WPA3" (aka "WPA3 with WPA2 as fallback") too, it is necessary to have wifi network cfg to be at least as this: 
network={
        ssid="MyWifiNetwork"
        key_mgmt=WPA-PSK-SHA256 WPA-PSK
        psk="MyPassword"
}
network={
        ssid="MyWifiNetwork"
        key_mgmt=WPA-PSK-SHA256 WPA-PSK
        psk="MyPassword"
}
(connect to pure WPA3 network is not possible due to lack of SAE authentication in kernel/wifi driver/wifi firmware... somewhere here. So the ability to connect using WPA2 to the WPA3 networks allowing WPA2 fallback is a small step, yet still makes big user experience improvement). Is it possible to make these changes in RatOS Configurator? thx
1 replies
RRCRat Rig Community [Unofficial]
Created by Kmarty on 4/26/2023 in #ratos-support
PAM & Optimus prime - unhandled exception in when bed is "full"
No description
13 replies
RRCRat Rig Community [Unofficial]
Created by Kmarty on 3/5/2023 in #ratos-support
PAM & Optimus Prime
@Helge Keck
Hi, is there a way how to properly set up "Optimus Prime". It mostly works, but it seems it has weak spot at the left front corner of the bed (following photos are examples of postions of print where print itself is repsented by one layer square frame surrounded by skirt)
180 replies
RRCRat Rig Community [Unofficial]
Created by Kmarty on 1/1/2023 in #ratos-support
High pitch noise when motors are stalling
No description
55 replies