NIL
RRCRat Rig Community [Unofficial]
•Created by NIL on 12/7/2024 in #ratos-support
Missing skew profile
@Helge Keck Ok, thanks for the solution, I haven't updated or kept up with the changes in months
10 replies
RRCRat Rig Community [Unofficial]
•Created by NIL on 12/7/2024 in #ratos-support
Missing skew profile
Is this a feature of ratos macros or were there some changes in klipper?
10 replies
RRCRat Rig Community [Unofficial]
•Created by NIL on 8/5/2024 in #ratos-support
Moving toolhead after priming to the initial print coordinate
What scares me is the moment when it jerks abruptly out of place after heating the bed, just that sharp contrast, and there are no mechanical problems.
14 replies
RRCRat Rig Community [Unofficial]
•Created by NIL on 8/5/2024 in #ratos-support
Moving toolhead after priming to the initial print coordinate
The harsh sound, it makes me cringe
14 replies
RRCRat Rig Community [Unofficial]
•Created by NIL on 8/5/2024 in #ratos-support
Moving toolhead after priming to the initial print coordinate
Yeah, it's oozing. Since the starting position of the print is at the opposite end, as a temporary solution I place the seam in that corner to minimize movement. Unfortunately the high movement speeds and accelerations in macros annoy me and I've limited them to 200/5000.
14 replies
RRCRat Rig Community [Unofficial]
•Created by NIL on 8/5/2024 in #ratos-support
Moving toolhead after priming to the initial print coordinate
No, this is at the ratos macro level, there is nothing like that in the gcode given by slicer
14 replies