lakshya Awana
RRCRat Rig Community [Unofficial]
•Created by lakshya Awana on 3/3/2025 in #fix-my-print
First layer test is good, skew test fails: nozzle hits after a couple of layers
Hi @TheTik . OKay i will try that, what if it does not move the same, will i have to do PA or flow calibration?. Is there a section on this discord that i can check to know how to do that.
15 replies
RRCRat Rig Community [Unofficial]
•Created by lakshya Awana on 3/3/2025 in #fix-my-print
First layer test is good, skew test fails: nozzle hits after a couple of layers
Does it mean that its set now
15 replies
RRCRat Rig Community [Unofficial]
•Created by lakshya Awana on 3/3/2025 in #fix-my-print
First layer test is good, skew test fails: nozzle hits after a couple of layers
@TheTik While printing the cube this is what the console said
15 replies
RRCRat Rig Community [Unofficial]
•Created by lakshya Awana on 3/3/2025 in #fix-my-print
First layer test is good, skew test fails: nozzle hits after a couple of layers
15 replies
RRCRat Rig Community [Unofficial]
•Created by lakshya Awana on 3/3/2025 in #fix-my-print
First layer test is good, skew test fails: nozzle hits after a couple of layers
15 replies
RRCRat Rig Community [Unofficial]
•Created by lakshya Awana on 3/3/2025 in #fix-my-print
First layer test is good, skew test fails: nozzle hits after a couple of layers
Doing the test now with a cube
15 replies
RRCRat Rig Community [Unofficial]
•Created by lakshya Awana on 3/3/2025 in #fix-my-print
First layer test is good, skew test fails: nozzle hits after a couple of layers
Too much speed, the nozzle collects the petg. And had to lower the nozzle otherwise it doesn’t like to stick.
15 replies