3D Scharti
RRCRat Rig Community [Unofficial]
•Created by 3D Scharti on 11/23/2024 in #fix-my-printer
SSR not switching bed power
I found the problem
The 4028 pwm fan shorted the 12v rail on the octopus
I unplugged it and everything works fine now
Thanks
16 replies
RRCRat Rig Community [Unofficial]
•Created by 3D Scharti on 11/23/2024 in #fix-my-printer
SSR not switching bed power
Is there a way to manually switch PA1 on on the octopus?
16 replies
RRCRat Rig Community [Unofficial]
•Created by 3D Scharti on 11/23/2024 in #fix-my-printer
SSR not switching bed power
I put 24v at the crimped ends and it worked so no i did not change the wires
16 replies
RRCRat Rig Community [Unofficial]
•Created by 3D Scharti on 11/23/2024 in #fix-my-printer
SSR not switching bed power
the ssr has a status led that doesnt turn on
when i power it directly it turns on and gets warm
16 replies
RRCRat Rig Community [Unofficial]
•Created by 3D Scharti on 11/23/2024 in #fix-my-printer
SSR not switching bed power
no
16 replies
RRCRat Rig Community [Unofficial]
•Created by 3D Scharti on 11/23/2024 in #fix-my-printer
SSR not switching bed power
tried reflashing the board, didn´t change anything
16 replies
RRCRat Rig Community [Unofficial]
•Created by 3D Scharti on 11/23/2024 in #fix-my-printer
SSR not switching bed power
Motion system is working
16 replies
RRCRat Rig Community [Unofficial]
•Created by 3D Scharti on 11/23/2024 in #fix-my-printer
SSR not switching bed power
this pin is also not turning on
16 replies
RRCRat Rig Community [Unofficial]
•Created by 3D Scharti on 11/23/2024 in #fix-my-printer
SSR not switching bed power
i tried switching the pin
[heater_bed]
heater_pin: PA2
16 replies
RRCRat Rig Community [Unofficial]
•Created by 3D Scharti on 11/23/2024 in #fix-my-printer
SSR not switching bed power
the polarity is correct
And i already changed the octopos to a new one because i had it on hand
16 replies