lucasdm303
RRCRat Rig Community [Unofficial]
•Created by lucasdm303 on 4/21/2024 in #fix-my-printer
Front right Z motor not working
Hello,
My front right Z motor of my VCORE 3 300 almost never works whenever i start my printer.
For example i start the homing / tilt procedure and the motor is not working (no torque, no enable signal?).
Altough once it starts working ... it works perfectly ... I have no idea how to start debugging this since ultimately it is able to work properly.
I always try the stepper buzzing command before printing to make sure the motor will be working.
Any ideas? suggestions? Thanks in advance.
10 replies
RRCRat Rig Community [Unofficial]
•Created by lucasdm303 on 1/2/2024 in #fix-my-printer
Z Tilt fails
Whenever i start z tilt procedure my right z motor stops working.
I am able to do the homing procedure and i am able to run the following command flawlessly "STEPPER_BUZZ STEPPER=stepper_z2".
I am kind of stuck now and wonder if anyone else here is able to resolve this?
Cheers
1 replies