Evian
RRCRat Rig Community [Unofficial]
•Created by Evian on 4/20/2025 in #fix-my-printer
New Build. VCore 4 failed initial Z-Tilt after homing.
Hey everyone,
I'm running into an issue trying to get Z-Tilt working on my RatRig V-Core 4 (500mm). I've followed the commissioning guide carefully, but when I try to run Z-Tilt from the Moonraker UI, the process fails. Here's what happens:
1. I home the toolhead (XYZ) successfully.
2. I click the Z-Tilt button in the Moonraker UI.
3. The toolhead moves off the bed toward the endstops.
4. The bed raises to its maximum height.
5. The console throws the error: "No trigger on probe after full movement." What I’ve already checked:
- Beacon probe wiring and polarity – confirmed good
- Probe works fine during regular Z-homing
- Motors and axis directions are correct
- Firmware and config are up to date as of today Any idea what I might be missing? Should I define the parameters in the
2. I click the Z-Tilt button in the Moonraker UI.
3. The toolhead moves off the bed toward the endstops.
4. The bed raises to its maximum height.
5. The console throws the error: "No trigger on probe after full movement." What I’ve already checked:
- Beacon probe wiring and polarity – confirmed good
- Probe works fine during regular Z-homing
- Motors and axis directions are correct
- Firmware and config are up to date as of today Any idea what I might be missing? Should I define the parameters in the
[z_tilt] section or change anything else in the config? Happy to post logs or full config if needed. Thanks in advance!17 replies