vever001
RRCRat Rig Community [Unofficial]
•Created by vever001 on 8/30/2024 in #ratos-support
Version mismatch warning while the version is the same
forgot to mention, same message after flashing
4 replies
RRCRat Rig Community [Unofficial]
•Created by vever001 on 8/30/2024 in #ratos-support
Why was primeline removed?
I'm still on an orbiter 1.5. I think the filament path on the gear is not great, I have to update 🙂
5 replies
RRCRat Rig Community [Unofficial]
•Created by Sjef Romijn on 5/28/2023 in #ratos-support
Unable to read tmc uart 'extruder' register IFCNT
Confirmed, I updated, it works, thanks again!
34 replies
RRCRat Rig Community [Unofficial]
•Created by Sjef Romijn on 5/28/2023 in #ratos-support
Unable to read tmc uart 'extruder' register IFCNT
Thank YOU 🙂
34 replies
RRCRat Rig Community [Unofficial]
•Created by Sjef Romijn on 5/28/2023 in #ratos-support
Unable to read tmc uart 'extruder' register IFCNT
Hi, not sure where to post this but I recently upgraded to v2.1.0-RC1
I'm using an SKR pro 1.2 , initially had some motor uart pin assignment issues which seem now to be fixed after updating everything
But after that update I encoundered Unable to read tmc uart 'extruder' register IFCNT
The uart pin assigned to the extruder motor was wrong, should have been PE1 (don't recall what it was assigned to). So perhaps a pending issue with pin assignments for SKR 1.2
34 replies