SeY
RRCRat Rig Community [Unofficial]
•Created by SeY on 1/19/2024 in #fix-my-printer
Fully restarted after "START_PRINT"
16 replies
RRCRat Rig Community [Unofficial]
•Created by SeY on 1/19/2024 in #fix-my-printer
Fully restarted after "START_PRINT"
@miklschmidt @TheTik @Jamin Collins [v-core 3.1 400mm] Thank you guys, I’ll check the wiring today~
16 replies
RRCRat Rig Community [Unofficial]
•Created by SeY on 1/19/2024 in #fix-my-printer
Fully restarted after "START_PRINT"
I ran the following manually
START_PRINT EXTRUDER_TEMP=205 BED_TEMP=60
The issue remains,
1. [working] heating to bed 60ºC, extruder 150ºC
2. [working] Mesh bed probing
3. [crash and restarted] Heating extruder to 205ºC16 replies
RRCRat Rig Community [Unofficial]
•Created by SeY on 1/19/2024 in #fix-my-printer
Fully restarted after "START_PRINT"
I have removed the post at #ratos-support.
Sorry for causing a mess.
16 replies
RRCRat Rig Community [Unofficial]
•Created by SeY on 1/19/2024 in #fix-my-printer
Fully restarted after "START_PRINT"
I appreciate your help
I couldn't figure out what caused this issue as my minion and another V-core never had this issue
16 replies
RRCRat Rig Community [Unofficial]
•Created by SeY on 1/19/2024 in #fix-my-printer
Fully restarted after "START_PRINT"
Please find the attached file the klippy log
16 replies
RRCRat Rig Community [Unofficial]
•Created by SeY on 1/19/2024 in #fix-my-printer
Fully restarted after "START_PRINT"
Thank you for helping! Both RPi and Octopus are properly cooled, and normally the MCU overheat will show up a notification after restarting but it’s not the case…
16 replies
RRCRat Rig Community [Unofficial]
•Created by SeY on 1/19/2024 in #fix-my-printer
Fully restarted after "START_PRINT"
Thank you for helping! I’m away from my printer right now. I’ll attempt to regenerate the issue later today
16 replies