Ghostfighter10k Chris
RRCRat Rig Community [Unofficial]
•Created by fargo on 8/4/2024 in #german-support
Orbiter Filament Sensor auf Octopus
EBB´42 in der Version 2.1
42 replies
RRCRat Rig Community [Unofficial]
•Created by fargo on 8/4/2024 in #german-support
Orbiter Filament Sensor auf Octopus
So läuft es bei mir. Woher nimmst du die Pin´s?
42 replies
RRCRat Rig Community [Unofficial]
•Created by fargo on 8/4/2024 in #german-support
Orbiter Filament Sensor auf Octopus
[filament_switch_sensor toolhead_filament_sensor_t0]
pause_on_runout: False
event_delay: 0.1
switch_pin: ^toolboard_t0:PB3 # Green wire
runout_gcode:
_ON_TOOLHEAD_FILAMENT_SENSOR_RUNOUT TOOLHEAD=0
insert_gcode:
_ON_TOOLHEAD_FILAMENT_SENSOR_INSERT TOOLHEAD=0
[gcode_button toolhead_filament_sensor_button_t0]
pin: ^toolboard_t0:PB4 #yellow wire
release_gcode:
{% if (printer.print_stats.state == "printing") %}
_ON_TOOLHEAD_FILAMENT_SENSOR_CLOG TOOLHEAD=0
{% else %}
_ON_FILAMENT_SENSOR_BUTTON_PRESSED TOOLHEAD=0
{% endif %}
press_gcode:UNLOAD_FILAMENT
42 replies
RRCRat Rig Community [Unofficial]
•Created by fargo on 8/4/2024 in #german-support
Orbiter Filament Sensor auf Octopus
Kann berichten, läuft! I2C Pin´s nutzen! !!!BL Touch oder RGB Header läuft in das gleiche Problem wie o.g..!!!
42 replies
RRCRat Rig Community [Unofficial]
•Created by fargo on 8/4/2024 in #german-support
Orbiter Filament Sensor auf Octopus
Ist es denn möglich den Sensor direkt über das Toolhead Board anzuwickeln, 5V , PB9 und Ground vom Probe Connector, PD3 vom RGB header ?
42 replies