M.
RRCRat Rig Community [Unofficial]
•Created by M. on 1/1/2025 in #ratos-support
VOAC Z-Offset failing
Dear RR Community and Mods,
I'm currently commissioning my VC4 and am running into a issue during the VAOC Z-Offset Step.
I followed the official commissioning guide (now multiple times) to the most minute detail.
18:32
_VAOC_END
18:32
RatOS | VAOC: Control point was set: X248.533610 Y529.435123 Z-1.740000
18:32
_VAOC_SET_TOOL
18:31
Error during homing move: Move out of range: 248.533 529.436 -7.000 [0.000]
18:31
Error during homing move: Move out of range: 248.533 529.436 -7.000 [0.000]
18:31
Error during homing move: Move out of range: 248.533 529.436 -7.000 [0.000]
18:31
Error during homing move: Move out of range: 248.533 529.436 -7.000 [0.000]
18:31
shaper_type_y:mzv shaper_freq_y:0.000 damping_ratio_y:0.100000
18:31
shaper_type_x:mzv shaper_freq_x:0.000 damping_ratio_x:0.100000
18:31
Activating extruder extruder
18:31
RatOS | IDEX: Toolhead offset applied for T0: X=-0.01339148516015598 Y=0.10378400999150017 Z=0.0
18:31
RatOS | IDEX: Selecting T0..
18:31
RatOS | VAOC: Move T0 to control point: X211.032955 Y529.435782 Z-1.740000 IS_FIXED=True
18:31
RatOS | VAOC: T1 offset was set: X-0.013391 Y0.103784 Z0.000000
18:31
_VAOC_CALIBRATE_Z_OFFSET
18:31
RatOS | VAOC: Move toolhead: G1 X-0.137263 Y0.053566 F18000
18:31
_VAOC_MOVE X=-0.13726272289172384 Y=0.05356594064067271
or I get:
Error evaluating 'gcode_macro _VAOC_ENSURE_TOOLHEAD_WITHIN_CONTROL_POINT:gcode': gcode.CommandError: Unexpected y-coordinate detected, VAOC aborted. Expected 210.999 but got 248.499.
Please see attached for the Debug.zip23 replies