Julian Rothenbuchner
RRCRat Rig Community [Unofficial]
•Created by Julian Rothenbuchner on 3/21/2024 in #fix-my-printer
V-Core 3 - 500 | Bed tilt adjustment is unreliable: the differences in z-height do not converge
During the bed tilt adjustment, the range does not converge reliably, sometimes it only takes 1 or 2 retrys, sometimes upwards of 5 and often it aborts, since the range is increasing.
This issue started appearing over time, and happens both with a hot and a cold hotend and bed; I also already re-tightened the grub screws on the lead screw couplers.
My bed level sensor is a BlTouch, and I am using the rough PEI sheet, if that is important at all.
Anyone got any ideas? Thanks!
9 replies