derekw0486
RRCRat Rig Community [Unofficial]
•Created by derekw0486 on 4/18/2025 in #fix-my-printer
VCore 4 unknown chip pin 'probe'
Appreciate the Help
13 replies
RRCRat Rig Community [Unofficial]
•Created by derekw0486 on 4/18/2025 in #fix-my-printer
VCore 4 unknown chip pin 'probe'
13 replies
RRCRat Rig Community [Unofficial]
•Created by derekw0486 on 4/18/2025 in #fix-my-printer
VCore 4 unknown chip pin 'probe'
That seemed to do the trick, klipper is back up and running again
13 replies
RRCRat Rig Community [Unofficial]
•Created by derekw0486 on 4/18/2025 in #fix-my-printer
VCore 4 unknown chip pin 'probe'
13 replies
RRCRat Rig Community [Unofficial]
•Created by derekw0486 on 4/18/2025 in #fix-my-printer
VCore 4 unknown chip pin 'probe'
running it now
13 replies
RRCRat Rig Community [Unofficial]
•Created by derekw0486 on 4/18/2025 in #fix-my-printer
VCore 4 unknown chip pin 'probe'
I did not left everything stock. After I reflashed the OG firmware when I had this problem the first time, I ran the configurator and everything was fine. I updated RAT OS, the configurator, then "all." Then restart klipper and boom, had the 'probe' chip name problme again
13 replies
RRCRat Rig Community [Unofficial]
•Created by derekw0486 on 4/18/2025 in #fix-my-printer
VCore 4 unknown chip pin 'probe'
I can't. With the Klipper error I just get a bad gateway 505 code if I try to go to the configurator. I can edit the .config files, but klipper won't run with the error.
13 replies