TheTrashPanda
RRCRat Rig Community [Unofficial]
•Created by TheTrashPanda on 4/27/2025 in #ratos-support
T1 hotend trouble
Don’t know if this is the right place to post this but I’m running out of ideas.
With VC4 IDEX when I try to set T1 heat or heat it up with Load Filament macro it doesn’t heat up. Mainsail says “heater extruder1 not supported”. But if I run a T1 hotend PID it heats up exactly as intended. Both T0 & T1 are setup the same (Rapido 2 UHF and Orbiter v2) only difference is beacon on T0. T0 works fine consistently. Only T1 says “heater extruder1 not supported” have check printer.cfg and RatOS.cfg for any obvious differences but have not noticed anything. Please help, VAOC cal went pretty good, just want to load and test T1 thanks!
25 replies