Doctor
RRCRat Rig Community [Unofficial]
•Created by Doctor on 9/17/2024 in #ratos-support
How do I create a new printer configuration?
19 replies
RRCRat Rig Community [Unofficial]
•Created by Doctor on 9/17/2024 in #ratos-support
How do I create a new printer configuration?
it seems that there is a problem that makes it almost impossible to change the head parameters other than those existing for official idex printers
19 replies
RRCRat Rig Community [Unofficial]
•Created by Doctor on 9/17/2024 in #ratos-support
How do I create a new printer configuration?
19 replies
RRCRat Rig Community [Unofficial]
•Created by Doctor on 9/17/2024 in #ratos-support
How do I create a new printer configuration?
Now, when I try to create a configuration with IDEX, I encounter this error
at the same time, at some point it started working, but then it stopped again (
the same thing happened with the microstep, at some point I got 128, but then it started showing 64 again and ignoring the settings in json
19 replies
RRCRat Rig Community [Unofficial]
•Created by Doctor on 9/17/2024 in #ratos-support
How do I create a new printer configuration?
19 replies
RRCRat Rig Community [Unofficial]
•Created by Doctor on 9/17/2024 in #ratos-support
How do I create a new printer configuration?
Now I tried to change the contents of the /home/pi/ratos-configurator/templates/voron-v24.ts file, but it didn't lead to anything. Also, after deleting this file, no error appeared, from this I make the assumption that the file I need with the same name and content is not used directly from this folder. probably, adding your own file to this folder did not lead to a positive result.
19 replies
RRCRat Rig Community [Unofficial]
•Created by Doctor on 9/17/2024 in #ratos-support
How do I create a new printer configuration?
19 replies
RRCRat Rig Community [Unofficial]
•Created by Doctor on 9/17/2024 in #ratos-support
How do I create a new printer configuration?
19 replies