Rhino
RRCRat Rig Community [Unofficial]
•Created by Rhino on 1/9/2024 in #fix-my-mesh
V3.1 400 enclosed bed mesh
Hey everyone hope your all doing well!
I am working on my V3.1 400 enclosed printer.
I am having a heck of a time with my first layer and my bed mesh since replacing the left and right X axis joiners due to my first set cracking.
The first mesh looks as if the back two corners are very low and the back center is higher leading me to think something is bowed however the front of the bed looks relatively flat. SEE MESH 1
Thinking that the gantry rail was bowed I loosened and re set the rail and also adjusted the front corner of the frame based off the frame squaring video. SEE MESH 2
The last mesh is after I heat soaked the printer. SEE MESH 3. Its really bowed now. Any help is greatly appreciated.
4 replies