jeremi5382
RRCRat Rig Community [Unofficial]
•Created by jeremi5382 on 12/27/2024 in #ratos-support
RatOS v2.1.0-RC3-20-g90dce855 First Layer Inconsistencies
I am probably doing something wrong regarding beacon contact usage. I have followed the guide here several times without ultimate sucess. https://os.ratrig.com/docs/configuration/beacon_contact.
I am running the initial calibrate, getting success with some gantry twist, have tried automated Beacon Scan Compensation as well.
Seemingly I have an issue where after the prime blob it adds the temp offset comp but its either too high or too low without much consistencies. If I turn off temp offset comp and manual step during first part it completes fine. I run this in console, SAVE_Z_OFFSET as instructed. Next print its usually too close but ocasionally not, I am not seeing anything on the nozzle. any advice on how to debug this? Still learning the ratos config file structure and what impacts what and best beacon workflow.
9 replies