jd
jd
RRCRat Rig Community [Unofficial]
Created by jd on 3/9/2025 in #ratos-support
Unable to print back to back in IDEX COPY mode
Like the title say : first print goes well, then to start second print, I home the printer, select Idex Copy, then start the print using the same file used for the first print (from Mainsail interface, without sending it from the slicer), but after the startup sequence, only the T0 toolhead is used to print, while T1 just sit on it's park spot. Note that while printing the second iteration T0 is not in the center of the bed, but at the correct left position for an Idex print. To make it work again, I have to restart the firmware. Any ideas ? Specs : - vcore 4 - 300mm Idex - RatOs Core v2.1.0-RC3-26-g33980992 - Klipper v0.12.0-396-gb7233d11 - moonraker v0.9.3-0-g71f9e677
12 replies