Mushroom
RRCRat Rig Community [Unofficial]
•Created by Mushroom on 10/25/2024 in #fix-my-printer
Z-Tilt issues (most likely awd causing this)
lowered acceleration and z tilt speed and now it seems to work fine, just a little off so i need to figure that out (too far to the left on bed meshing and too far to the right on z tilt
6 replies
RRCRat Rig Community [Unofficial]
•Created by Mushroom on 10/25/2024 in #fix-my-printer
Z-Tilt issues (most likely awd causing this)
Just want to post more info again! Im using this for awd.
https://www.printables.com/model/446124-full-metal-awd-mod-with-belt-tensioners-for-the-ra
I have a feeling I have some of the motors or steppers connected wrong. I have both left motors (rear and front) connected to either Y or X axis (upper belt) and both on the right to lower belt.
All edits in the code is in my printer cfg. 99% of it is in the bottom of the cfg. Nothing in the actual ratos files.
Im super sorry if im breaking any rules by commenting on my post. I tried to find all the rules and read them so I dont accidentally break them.
6 replies
RRCRat Rig Community [Unofficial]
•Created by Mushroom on 10/25/2024 in #fix-my-printer
Z-Tilt issues (most likely awd causing this)
Motors are connected like this:
Front left (XY-upper belt) driver 6
Front right (XY-lower belt) driver 2
Rear right (XY-lower belt) driver 0
Rear left (XY-upper belt) driver 4
Z rear - driver 3
Z right - driver 7
Z left - driver 1
Extruder - ebb42
(Driver numbers in octopus pro pinout, not my cfg)
6 replies