SolemBurn
RRCRat Rig Community [Unofficial]
•Created by deep-jade on 5/5/2023 in #fix-my-printer
Z Probe always TRIGGERED, even when the probe is disconnected
Ok here is my solve:
after change from mini super pinda to cheap cnc probe needed to change pin prefix to ~ instead of ^
16 replies
RRCRat Rig Community [Unofficial]
•Created by rising-crimson on 5/5/2023 in #fix-my-printer
Z Probe always TRIGGERED, even when the probe is disconnected
im also using cnc inductive probe NPN NC, plugged in J40 port on BTT Octopus 446, and probe doesnt change a state
16 replies
RRCRat Rig Community [Unofficial]
•Created by diverse-rose on 5/5/2023 in #fix-my-printer
Z Probe always TRIGGERED, even when the probe is disconnected
Did any of You guys resolved this problem?
16 replies
RRCRat Rig Community [Unofficial]
•Created by 3DBoomer on 2/5/2024 in #fix-my-printer
No access to Mainsail interface since full Ratos Update this AM
Hi, have the same problem, did You find a solution or just reinstall RatOS
4 replies
RRCRat Rig Community [Unofficial]
•Created by Jingleheimer on 1/23/2024 in #fix-my-printer
Temperature drops cause Klipper to hault
check if Your fan isnt cooling hotend too much, this was mine issue, and i must limit fan output at max 40%
11 replies