cmog
RRCRat Rig Community [Unofficial]
•Created by Jingleheimer on 1/23/2024 in #fix-my-printer
Temperature drops cause Klipper to hault
Finally found the problem. It was cabeling of the tool fan. Die copper inside the isolation was broken and on special movement of the extruder it lost sporadic contact. The difficulty was to find the location, because it was not at the end or beginning of the cable shielding, nearly in the middle,....But not reacting on vibration only at special angles,... so at the end I renewd the whole cableset to the extruder,...
11 replies
RRCRat Rig Community [Unofficial]
•Created by Jingleheimer on 1/23/2024 in #fix-my-printer
Temperature drops cause Klipper to hault
I printed with exactly thsi setup at least 50kg PETG and more then 2000h . The only thing I changed from time to time is updating the firmware and modules,... At the moment I have issues to flash the board at all
11 replies
RRCRat Rig Community [Unofficial]
•Created by Jingleheimer on 1/23/2024 in #fix-my-printer
Temperature drops cause Klipper to hault
Additional I tried another SD-card, but no success,....
After this last night I scrolled trough the commits and found some "improvments" regarding the Octopus-boards. Next step for me is to downgrade back to older firmware
11 replies
RRCRat Rig Community [Unofficial]
•Created by Jingleheimer on 1/23/2024 in #fix-my-printer
Temperature drops cause Klipper to hault
before 150 and 210° it was calibrating heightmap
11 replies
RRCRat Rig Community [Unofficial]
•Created by Jingleheimer on 1/23/2024 in #fix-my-printer
Temperature drops cause Klipper to hault
11 replies
RRCRat Rig Community [Unofficial]
•Created by Jingleheimer on 1/23/2024 in #fix-my-printer
Temperature drops cause Klipper to hault
11 replies