Baloo992013
RRCRat Rig Community [Unofficial]
•Created by Baloo992013 on 10/5/2024 in #fix-my-printer
BLtouch deploying but not triggering
Yeah i had it wired like that but decided against the Bltouch after seeing in some videos how long it takes to level the bed.
So now i switched to a super pinda instead.
Thanks though!
5 replies
RRCRat Rig Community [Unofficial]
•Created by Baloo992013 on 10/5/2024 in #fix-my-printer
BLtouch deploying but not triggering
Update 2:
If i use the "pin_up_touch_mode_reports_triggered: false", then the Error message while homing is:
"BLTouch failed to raise probe"
If i use both "pin_up_touch_mode_reports_triggered: false" and "pin_up_reports_not_triggered: False", the error message is:
"BLTouch failed to deploy"
With just "pin_up_reports_not_triggered: False" and "#pin_up_touch_mode_reports_triggered: false", so quoted out, the error is:
"BLTouch failed to verify sensor state"
With both disabled, so no overwrites, I got:
"BLTouch failed to verify sensor state"
Update 3:
Tried all the above with the black & white wire switched (BR-RE-YE-WI-BL) in the same order with those results:
1. The Pin deploys but doesnt use the input so i had to use e-stop
2. The Pin deploys but doesnt use the input so i had to use e-stop
3. "BLTouch failed to verify sensor state"
4. "BLTouch failed to verify sensor state"
...fml
5 replies
RRCRat Rig Community [Unofficial]
•Created by Baloo992013 on 9/9/2024 in #fix-my-printer
Ethernet instead of USB-C?
Hi it worked before but lost connection after not running the printer.
This is a new flash i just did, as recomaned by the Klipper doc after trying the same cable in every USB-A socket on the Pi.
The Pi i also powered by a Rasperberry Pi powersupply/plug
4 replies