smndcr
RRCRat Rig Community [Unofficial]
•Created by smndcr on 6/2/2024 in #fix-my-printer
vcore 3.1 z-tilt issue
Haha I had endstop mounted to opposite side
22 replies
RRCRat Rig Community [Unofficial]
•Created by smndcr on 6/2/2024 in #fix-my-printer
vcore 3.1 z-tilt issue
Thank you so much
22 replies
RRCRat Rig Community [Unofficial]
•Created by smndcr on 6/2/2024 in #fix-my-printer
vcore 3.1 z-tilt issue
This is what its doing now
22 replies
RRCRat Rig Community [Unofficial]
•Created by smndcr on 6/2/2024 in #fix-my-printer
vcore 3.1 z-tilt issue
22 replies
RRCRat Rig Community [Unofficial]
•Created by smndcr on 6/2/2024 in #fix-my-printer
vcore 3.1 z-tilt issue
Now after swapping when I home X it goes to opposite direction
22 replies
RRCRat Rig Community [Unofficial]
•Created by smndcr on 6/2/2024 in #fix-my-printer
vcore 3.1 z-tilt issue
22 replies
RRCRat Rig Community [Unofficial]
•Created by smndcr on 6/2/2024 in #fix-my-printer
vcore 3.1 z-tilt issue
Just then lets see
22 replies
RRCRat Rig Community [Unofficial]
•Created by smndcr on 6/2/2024 in #fix-my-printer
vcore 3.1 z-tilt issue
I did swap the X Y stepper
22 replies
RRCRat Rig Community [Unofficial]
•Created by smndcr on 6/2/2024 in #fix-my-printer
vcore 3.1 z-tilt issue
Thats what I did. But, I did have to swap the stepper physically even though I followed the guide. Never faced such problems before. Wired as I built over Dozen of Vorons and never encountered the issue. However, still not sure what to do about z tilt. I did manage to home X Y successfully
22 replies
RRCRat Rig Community [Unofficial]
•Created by smndcr on 6/2/2024 in #fix-my-printer
vcore 3.1 z-tilt issue
22 replies
RRCRat Rig Community [Unofficial]
•Created by smndcr on 6/2/2024 in #fix-my-printer
vcore 3.1 z-tilt issue
Z tilt
22 replies
RRCRat Rig Community [Unofficial]
•Created by smndcr on 6/2/2024 in #fix-my-printer
vcore 3.1 z-tilt issue
Homing
22 replies
RRCRat Rig Community [Unofficial]
•Created by smndcr on 6/2/2024 in #fix-my-printer
vcore 3.1 z-tilt issue
22 replies