AirBlast de Lezo
RRCRat Rig Community [Unofficial]
•Created by AirBlast de Lezo on 2/17/2025 in #fix-my-printer
Can't launch beacon initial calibration
Good evening. I've been several hours trying to fix a problem with beacon and Z-axis.
First problem: When I try to homing the printer, it throws this error: Must home axis first: 0.000 0.000 15.000 [100.000]
It can be solved using "SET_CENTER_KINEMATIC_POSITION" and the launching "BEACON_RATOS_CALIBRATE" or "BEACON_INITIAL_CALIBRATION". X and Y home perfectly, but when Z is homing, the error it's shown is "no beacon model loaded" and I can't go further this point. I've been searching for a while but any answer helped me. I'm on RatOS 2.1 and everything is up to date.
Thank you
P.S: On config there are these lines:
[gcode_macro RatOS]
variable_beacon_contact_z_homing: False
variable_beacon_contact_start_print_true_zero: False It was just a test I made to check if I could fix it like this but no luck either
variable_beacon_contact_start_print_true_zero: False It was just a test I made to check if I could fix it like this but no luck either
2 replies