Arristor
RRCRat Rig Community [Unofficial]
•Created by karpkapital on 12/24/2024 in #ratos-support
Unknown g-code generator
When using the START_PRINT macro, now it works. But klipper heating the Extruder to default 150 degrees and the prime blob moves the extruder outside the bed. Drives Z to 50mm up, down and prime the blob on air. I dont like to use macros. I just want it like it was for RatOS 2.1. Without this constraint of any fixed slicers.
33 replies
RRCRat Rig Community [Unofficial]
•Created by karpkapital on 12/24/2024 in #ratos-support
Unknown g-code generator
Yes it is
33 replies
RRCRat Rig Community [Unofficial]
•Created by karpkapital on 12/24/2024 in #ratos-support
Unknown g-code generator
@Helge Keck On Ratos2.1 my print is aborted after start. allow_unsupported_slicer_Versions: True
bypass_post_processing: True, are ignored and my print stops. Your line above is not valid in section ratos.
33 replies
RRCRat Rig Community [Unofficial]
•Created by Arristor on 1/6/2025 in #ratos-support
Disable postprocessing
Ohh God. You should be able to read. I mixed up German and English. Thank you anyway
5 replies