no_c2h5oh
RRCRat Rig Community [Unofficial]
•Created by Helge Keck on 11/28/2024 in #ratos-support
VC4 IDEX Endstop calibration test
idex_xoffset = 0.08171275776905418
118 replies
RRCRat Rig Community [Unofficial]
•Created by Helge Keck on 11/28/2024 in #ratos-support
VC4 IDEX Endstop calibration test
This procedure definitely works and the official commissioning guide should be changed, as soon as possible, for the others to follow.. Thank you all!
118 replies
RRCRat Rig Community [Unofficial]
•Created by Helge Keck on 11/28/2024 in #ratos-support
VC4 IDEX Endstop calibration test
Sure, I apologize
118 replies
RRCRat Rig Community [Unofficial]
•Created by Helge Keck on 11/28/2024 in #ratos-support
VC4 IDEX Endstop calibration test
Currently at 10k, starting the VAOC procedure brings me "moove out of range"
118 replies
RRCRat Rig Community [Unofficial]
•Created by Helge Keck on 11/28/2024 in #ratos-support
VC4 IDEX Endstop calibration test
I tuned my Prusament PC-Blend from ground up, achieving a very good precision even better than my enclosed MK3S+ (all enclosed chambers). Never reached more than 6000 acceleration on the RatRig - above that quality is ridiculous for my needs... How would you advise on tuning belts properly? I'm using the Diyshift GT2 belt tensioner...
118 replies
RRCRat Rig Community [Unofficial]
•Created by Helge Keck on 11/28/2024 in #ratos-support
VC4 IDEX Endstop calibration test
So probably I'm not tuning my belts properly, even with the Hybrid 500 - 10K was unachievable for any meaningful print quality
118 replies
RRCRat Rig Community [Unofficial]
•Created by Helge Keck on 11/28/2024 in #ratos-support
VC4 IDEX Endstop calibration test
Apparently, all my problems (IDEX 500) with the "Move out of range:" were due a faulty back_clamp, that didn't hold the belt properly in combination with the default acceleration been set to 10000mm, which is a bit aggressive for a 500?
118 replies