jet
RRCRat Rig Community [Unofficial]
•Created by JaminCollins on 5/3/2024 in #ratos-support
LGX Lite configured (by default) to run HOT (out of spec)
15 replies
RRCRat Rig Community [Unofficial]
•Created by JaminCollins on 5/3/2024 in #ratos-support
LGX Lite configured (by default) to run HOT (out of spec)
interesting. thank you.
15 replies
RRCRat Rig Community [Unofficial]
•Created by JaminCollins on 5/3/2024 in #ratos-support
LGX Lite configured (by default) to run HOT (out of spec)
2. question:; why in steppers config extruder stepper has 64 microsteps but bontech say 16 microsteps is right. 64 microsteps can heating stepper motor more??
15 replies
RRCRat Rig Community [Unofficial]
•Created by JaminCollins on 5/3/2024 in #ratos-support
LGX Lite configured (by default) to run HOT (out of spec)
hhelp pls. if i dont put stepper config for lgx lite motor in the printer.cfg than its 0.5a? Because its in vcore3 config 0.5.
15 replies