Hilm
Hilm
RRCRat Rig Community [Unofficial]
Created by Hilm on 1/13/2024 in #ratos-support
check board status failure
@miklschmidt Oh no, It turns out, I wasn't connected to the internet and wasn't aware of it. So I did it again. Now everythings looks fine. I will go on with wiring etc. Sorry to bother you and thank you very much! 🙂
19 replies
RRCRat Rig Community [Unofficial]
Created by Hilm on 1/13/2024 in #ratos-support
check board status failure
No description
19 replies
RRCRat Rig Community [Unofficial]
Created by Hilm on 1/13/2024 in #ratos-support
check board status failure
@miklschmidt Thank you so much, it worked! The board flashed. Unfortunatly Klipper did not run. So I chut down mailsail through the UI to start again. But now I can not connect to the PI. Do you have any clou why?
19 replies
RRCRat Rig Community [Unofficial]
Created by Hilm on 1/13/2024 in #ratos-support
check board status failure
No description
19 replies
RRCRat Rig Community [Unofficial]
Created by Hilm on 1/13/2024 in #ratos-support
check board status failure
The octopus gets its power through USB
19 replies
RRCRat Rig Community [Unofficial]
Created by Hilm on 1/13/2024 in #ratos-support
check board status failure
I am on a Mac. That doesn't read files on the SD card. 😦
19 replies
RRCRat Rig Community [Unofficial]
Created by Hilm on 1/13/2024 in #ratos-support
check board status failure
Everything is unplugged, except the USB. How do I confirm the change to .cur?
19 replies